12 | Pro-Stitcher Lite for the Baby Lock Gallant/Villa Frame
www.ProStitcher.com
Installing the Pro-Stitcher Lite Assembly on the
Gallant
These instructions are for installing Pro-Stitcher Lite on the Gallant machine and the Villa frame.
Pro-Stitcher recommends installation by an authorized Pro-Stitcher retailer if available.
Tools required
• Power drill
• 2.5mm hex wrench
• 3mm hex wrench
• 4mm hex wrench
• 5mm hex wrench
• 9/16-inch open-end wrench
• 5/16-inch nutdriver (optional)
• Slotted screwdrivers (one large and one small)
• Phillips screwdrivers (one large and one small)
Installing the Pro-Stitcher Lite Tray Assembly
These instructions are for installing the Pro-Stitcher Lite Tray Assembly.
1. Locate the Pro-Stitcher Lite tray assembly,
screws, and washers
(see Parts List, item E)
.
2. Place the carriage
(not shown in Parts List)
upside down on a protected flat surface with the
wheels up toward the ceiling.
3. Use the 3mm hex tool to remove and discard
the six screws and washers, which are located in
the
outside inserts
holding the track supports to
the top of the carriage as shown.
Â
IMPORTANT
: There will still be two outside
screws close together on each end of the
track support holding the tracks in position
and in place on the carriage at this point. Do
not remove these screws. They are keeping
the tracks aligned in position.
