8
AXIS 241Q/S/QA/SA - Product Description
DIP Switches
- upon delivery the AXIS 241S/SA is configured for composite video input.
Note:
If the AXIS 241S/SA is to be connected in loop-through with other equipment, disable the input termina-
tion by setting switch 1 to the up-position (OFF). Failure to do this may cause reduced image quality.
Control Button
- Press this button to restore the factory default settings, as described in
Resetting to the Factory Default Settings,
on page 46, or to install using AXIS Internet
Dynamic DNS Service, see page 16.
Video Input
- Coaxial BNC connector supporting a single composite video source. The
physical connection is made using 75 Ohm coax video cable with a recommended
maximum length of 800 feet (250 meters).
Note:
The AXIS 241S/SA supports conversion between composite video and Y/C (S-video) using an Y/C to BNC
cable.
Video Output
- A single video loop-through (VIDEO OUT) connected in parallel with
VIDEO IN and terminated with a coax/BNC connector. Allows direct connection of e.g. an
external monitor. Set DIP switch to OFF when in use.
Line Out
(AXIS 241SA only) - Mono audio output (line level), which can be connected to a
public address (PA) system or an active speaker with a built-in amplifier. A pair of
headphones can also be attached.
Line/Mic In
(AXIS 241SA only) - One 3.5mm input for a mono microphone, or for line-in
mono signal (only the left channel is used from a stereo signal).
Video Server Rear Panel
Power Supply Connector
- A single socket for connection of the PS-K power adapter.
Switch
1
2
3
4
Description
75 ohm video in
termination
75 ohm video out
termination
Connects video in and
video out
Not used
Composite video input
on
off
on
n/a
Y/C video input
on
on
off
n/a
The
Serial Number
is
located on the label
on the underside of
the unit.
