Operation instructions | MK 8-0x | MK 16-0x | MK 8-2x | MK 8-0xN | MK 12-0xN
68
2022-07-27 | Technical improvements, changes in design, printing- and other errors reserved.
6.2.1.
Using CI menu and rebooting the CAM
The content of the CI menu depends on the CAM manufacturer and the card being used. Depending on the
manufacturer, various settings are possible. Information on validity and authorisation are the most important.
Please observe the operating instructions provided by the manufacturer.
According to the used CAM different settings can be done. Most important is getting information about
authorisation.
The input and navigation field is used for navigation within the CI menu.
Use
Up
or
Down
to reach a higher or lower selection point.
Use
Ok
to enter a corresponding sub menu or confirm a selection.
Use
Menu
to come back to the next superordinate level.
Use
Exit
to leave the menu.
6.2.2.
Bit rate for high-speed CAM and restarting the CAM
Bit rate
The bit rate is factory set to "Auto". The bitrates of the most common CAM are thus recognized. If necessary,
the bit rate can also be set manually.
Select the desired bitrate in the
Bitrate
field.
For example, select 105 Mbps for a high-speed CAM
Reboot the CAM
The CAM can be rebooted if necessary.
Click CI1…6 to reboot it.
The Content depends on used
CAM
Input and navigation field
