AVT MAGIC ISDN, Описание аппаратуры

Страница: 13 / 66

PAGE 13
Q U I C K I N T R O D U C T I O N
1.1.2 Putting into operation
(1) Switch on the MAGIC system (mains switch at front)
(2) Switch on the PC.
(3) Install the PC operating software (remember to make a backup copy!):
– Insert disk
– Install the software on the hard disk by typing
CKPUVCNN
– When the required directory is requested, simply press RETURN
and the software is installed in the default directory which is shown
in brackets.
(4) Start the program:
OCIAKUFP
or
OCIAO
, depending on which version is
required. In the lower right corner of the screen, the message PC-
CONN indicates that the connection between PC and MAGIC system
is in order.
FIGURE 1.2 AFTER SWITCHING ON, THE SYSTEM TAKES APPROXIMATELY 60 SECONDS TO BOOT UP.
DURING THIS TIME THE MESSAGE PC-DROP IS DISPLAYED IN THE LOWER RIGHT CORNER
OF THE PC SCREEN.
(5) To avoid faulty installation, first of all load the factory settings: click with
the mouse on the word CONFIG in the top row of the screen. Under the
pull-down menu which opens, move the mouse pointer to
FACTORY SETTINGS and click on this. The settings are now loaded.
1.1.3 Setting up the call
(1) To set up the charge display, click on the CHARGES key. In the panel
which opens you can enter the current CHARGE FACTOR. This factor
is the cost for each charge unit. Additionally, under CURRENCY, the
currency to be displayed can be entered. The settings are immediately
stored in non-volatile memory.
REMARK With the 1TR6 national protocol, the charging impulses are
normally provided. With DSS-1 protocol, these must be reque-
sted.
(2) Change to the LINE panel and select your ISDN protocol. The settings
are immediately stored in non-volatile memory.
(3) Activate the CALL panel: click the word CALL in the top row of the
screen with the mouse.
(4) If the MAGIC System is connected through a PABX, the prefix number
for the outside line can be entered under PREFIX NO.
(5) Open the window for the entry of numbers: Click the MANUAL CALL
key in the right part of the screen.
(6) Enter the calling numbers:
– AREA CODE: Enter the (country and) area codes
– NUMBER 1: Calling number of the first B channel
– NUMBER 2: Calling number of the second B channel
(7) Set up the call: Click the CALL key with the mouse
The remote side must also be operational and have the factory settings
loaded.