Avidyne FlightMax EX500, Руководство по установке

Страница: 66 / 124

Installation Manual
Radar Sensor Setup P/N 600-00175-000 Rev 04
- 56 -
3. Set the TILT SETTING to 15.0D. The fault fields will flash indicating that your settings are
being saved. If the save procedure is successful, the GYRO fault will disappear and the
azimuth count will cycle through its entire number range.
Note:
For an example, see step S.
4. If the GYRO fault remains, set TILT to 0 and repeat step 3.
5. After saving the configuration, this section is complete.
➥
For radar with an ARINC 429 gyro, start here after completing step L.
Q. Calibrate AHRS ARINC 429 PITCH OFFSET
1. Adjust the GAIN buttons for a GAIN POT /2 setting to 11- or 12-.
2. Check that the tilt table is set for 0
o
pitch.
3. Set the PITCH ANGLE field to 0.0 ±1.0
o
.
◆
To increment the value of the PITCH ANGLE, use the right inner knob to change the TILT
SETTING to between 5 and 10 UP. When the TILT SETTING is set to between 5 and 10
UP, the value of the PITCH ANGLE field will slowly increase.
◆
To decrement the value of PITCH ANGLE, use the right inner knob to change the TILT
SETTING to between 5 and 10 DOWN. When the TILT SETTING is set to between 5 and
10 DOWN, the value of the PITCH ANGLE field will slowly decrease.
◆
When you reach the desired setting, quickly adjust the TILT SETTING to above 10 UP to
lock in the setting.
4. Set the tilt table to 10
o
pitch up. The value should be 10.0U ±1.0
o
. If the value is out of range,
repeat Steps 1, 2 and 3 of this section.
5. Set the tilt table to 10
o
pitch down. The value should be 10.0D ±1.0
o
. If the value is out of
range, repeat Steps 1, 2, 3 and 4 of this section.
6. Set the tilt table to 0
o
pitch. The value should be 0.0 ±1.0
o
.
7. Proceed to step R.
R. Calibrate AHRS ARINC 429 ROLL OFFSET
1. Adjust the GAIN controls for a GAIN POT setting to between 7- and 9-.
2. Check that the tilt table is set for 0
o
roll.
3. Set the ROLL ANGLE field to 0.0 ±1.0
o
.
◆
To increment the value of the ROLL ANGLE, use the right inner knob to change the TILT
SETTING to between 5 and 10 UP. When the TILT SETTING is set to between 5 and 10
UP, the value of the PITCH ANGLE field will slowly increase.
◆
To decrement the value of ROLL ANGLE, use the right inner knob to change the TILT
SETTING to between 5 and 10 DOWN. When the TILT SETTING is set to between 5 and
10 DOWN, the value of the ROLL ANGLE field will slowly decrease.
◆
When you reach the desired setting, quickly adjust the TILT SETTING to above 10 UP to
lock in the setting.