Avidyne FlightMax EX500, Руководство по установке

Страница: 42 / 124

Installation Manual
GPS/FMS Navigators Setup P/N 600-00175-000 Rev 04
- 32 -
■ Speed— There are two speeds available, High and Low. See Table 12, “GPS/FMS
Manufacturer’s Matrix,” on page 30 to determine the correct speed for your system.
3. When you are done, press Save to save your changes. Press Cancel to exit without saving
changes.
4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press
Restart System .
5.5.2 Dual GPS Setup with GAMA 429
The EX500/EX600 can receive information from two GAMA 429 Graphics capable GPS units. Connect
the GPS according to the wiring diagram in Appendix G:
GPS/FMS System Wiring , on page 96, using
a different ARINC port for GPS2. Follow the setup instructions in Section 5.5.1.
5.5.3 RS-232 Setup
If your GPS uses an RS-232 configuration, use Appendix G: GPS/FMS System Wiring , on page 96 for
wiring information.
Note:
An RS-232 interface does not provide for heading data from the GPS/FMS.
➤
To set up the MFD for the RS-232 Interface:
1. From the Maintenance Mode Page, press GPS Setup . The GPS Setup Page displays.
2. Configure the interface as follows:
■
Receiver— Select the receiver-type for your GPS/FMS system. Determine the RS-232 output
format using Table 12, “GPS/FMS Manufacturer’s Matrix,” on page 30 or your GPS/FMS
Installation manual. Select one of the following RS-232 formats:
◆
NMEA 0183
◆
King/Aviation Format
◆
Northstar Format
■
Port— Select RS232 1, or as wired.
■
Baud— Select the highest-possible baud rate for your GPS/FMS system. See the appropriate
GPS/FMS Installation manual or see Table 12, “GPS/FMS Manufacturer’s Matrix,” on page 30
to determine for the maximum speed.