Avery Weigh-Tronix WPI-135, Руководство по обслуживанию

Страница: 33 / 75

33
• Software version of the cell (vD.A in this example)
For analog scales you are shown:
• a raw count value and its equivalent mV/V value. (These
values should be positive and increase as weight is applied.
SERIAL Use this to test your ports. Select Port #1 through 4 then short
the TX and RX on the selected port. The display will change
from NO LOOP to LOOP indicating the port is good. Jumper
RTS to CTS to test the handshake lines.
MORE Accesses the following keys:
INPUT Allows you to Activate/Deactivate any input setpoint device such
as a switch or contact closure remotely and monitor it with this
menu.
OUTPT Allows you to Activate/Deactivate any output setpoints to verify
correct hardware operation during installation or for trouble-
shooting purposes.
DISP This test continuously cycles the display through various pat-
terns.
NET This diagnostic will only appear if a network option card is
installed. Follow the instructions on the display.
Inputs and outputs have to be
defined in the WT-BASIC
program for them to work.