Avery Weigh-Tronix WPI-135, Руководство по обслуживанию

Страница: 22 / 75

22
Configure
—MENU2
—MORE
—RT / TO
ROC Mult
The ROC Multiplier allows you to enter a conversion factor to translate
weight to some other unit of measure, such as gallons or some other weight
unit based upon the calibration unit of measure.
ROC Examples:
If pounds is your calibration unit, pick a sample value of 60 and
a multiplier of 1. The display will show the rate of change in
pounds/second.
For gallons of water/second set the sample value at 60 and the
multiplier to 0.125. Water = 8 lbs/gallon (8 lbs is close enough
for our example) so their are 0.125 gallons per pound. See
formula to the left.
To get gallons/minute, do not change the sample size but rather
multiply the 0.125 by 60 to get a value equal to gallons/pounds/
minute (7.5). The display will then show you a rate of change in
gallons per minute. (This is the flow over the last second not
over a whole minute's time.)
If you press the ROC soft key, follow these instructions:
1. The display shows the current
value for SAMPLES. Press
ENTER to accept the current
value or key in a new one and
press ENTER. . .
The current multiplier value is
displayed.
2. Press ENTER to accept the
current value or key in a new one
and press ENTER. . .
The display returns to the
MENU2—MORE display.
Press this key to configure Print Return to Zero (RTZ), Accum RTZ, Accum
TimeOut, Print TimeOut, Zero TimeOut and Tare TimeOut.
For the RTZ functions, set the percent of capacity the weight must fall below
before another Print or Accum action can occur.
For the TimeOut functions, set the amount of time, in seconds, the indicator
will retry the function before it gives up.
If you press the RT / TO soft key, follow these instructions:
1. The current value for PRINT RTZ
is displayed. Press ENTER to
accept this value or key in a new
value and press ENTER. . .
The Accum RTZ value is displayed.
2. Repeat step 1 for Accum RTZ,
Accum TimeOut, Print Timeout,
Zero Timeout, and Tare
Timeout. . .
The display returns to the
MENU2—MORE display.
Press the ESC key twice to return to the CONFIGURE display.