Avery Weigh-Tronix WPI-135, Руководство по обслуживанию

Страница: 17 / 75

17
CTS is a hardware handshake
(ready/busy) which requires
two extra wires in your cable.
Xon/Xoff is a software hand-
shake requiring no additional
hardware.
Configuration
—MENU1
—KEYS
Configuration
—MENU1
—SERIAL
If you press the KEYS soft key, follow these instructions:
1. The display asks if you want to
enable the SELECT key
and shows you the current state
(
ON or OFF). If the condition is
as you want it, simply press the
ENTER key. If you want to
change the condition, press the
YES or NO soft key, then the
ENTER key to move to the next
key. . .
The UNITS key is the next one
shown.
2. Repeat step 1 for UNITS,
PRINT, TARE, ZERO,
AUTOTARE and KEYPAD
TARE . . .
The display returns to the MENU1
display.
If you press the SERIAL soft key, follow these instructions:
1. The display prompts you for
serial port # to configure. Press
ENTER if displayed port is OK or
key in a new port number and
press ENTER. . .
The baud rate is displayed.
2. Press ENTER to accept the
baud rate or key in a new baud
rate from the table below and
press ENTER. . .
The parity code number is displayed.
Baud Rates
300
9600
1200 19,200
2400 38,400
4800 56,700
3. Press ENTER to accept the
parity or key in a new parity code
number from the table below and
press ENTER. . .
The databits setting is displayed.
Parity Codes
0 = NONE
3 = SET
1 = ODD 4 = CLEAR
2 = EVEN
4. Press ENTER to accept the
databits setting or key in the new
databits value (7 or 8) and press
ENTER. . .
The handshake protocol code
number is displayed.