Avery Weigh-Tronix WPI-135, Руководство по обслуживанию

Страница: 10 / 75

10
The display mode you pick
may not be the one that
appears on the display. A
display mode called out in the
WT BASIC program overrides
the setting you make through
the front panel.
While in the this menu the
display will show USER-
SELECT in the top left to
remind you of where you are in
the USER menu.
User
— SELECT
—DISP
User
—SELECT
—SCALE
You cannot select a scale
number unless it has been
activated in the SimPoser
program and downloaded to
the WPI-135, or enabled in the
Config menu.
User
— SELECT
User
—SELECT
—TARE
Press the SELECT soft key to access the User—SELECT soft key group:
DISP Press this key to set the current display mode and active value
SCALE Press this key to select the scale number you want to use.
TARE Press this key to enter a known tare weight.
UNIT Press this key to select the active units of measure.
Following is a detailed description of the four functions listed above.
If you press the DISP soft key, follow these instructions:
1. The display shows the current
display mode number. Press
ENTER to accept this value or
key in a new number from the list
in Appendix 1, then press
ENTER to accept it.
The display asks for the ACTIVE
VALUE. This is the active display
value.
2. Choose one of the following
active display values by keying
in 0-13, then press ENTER. . .
The display returns to the USER-
SELECT screen.
0 = Gross 4 = Max 8 = Count Total 12=Piece Weight
1 = Net 5 = Rate of Change 9 = Trans. Total 13=ADC
2 = Tare 6 = Gross Total 10=Count
3 = Min 7 = Net Total 11=Variable
If you press the SCALE soft key the display will ask you to select a scale
number. The currently active scale number is displayed. You can simply
type a new scale number and press the ENTER key. If you have multiple
scales attached to the indicator, this function chooses which scale's weight
is displayed and which one the ZERO and TARE keys will affect.
If you press the TARE soft key the display will show the current tare value
for the active scale. You may key in a new tare weight and press the ENTER
key to override the previous tare weight.
Variable (#11) is a variable
value called out in a WT-
BASIC program. ADC (#13)
stands for Analog to Digital
Counts.