This section gives the information you need to set up and operate
your EZ-Read EZ-Read:
• Install New Batteries
• Configure the EZ-Read for Your Vehicle
• Set the Display Units (SAE/Metric)
• Connect the EZ-Read to Your Vehicle
Install New Batteries
The EZ-Read EZ-Read is powered by
4 AA batteries
.
Before the EZ-Read is used the first time, you need to
install batteries in the unit.
Make sure the batteries are put in according to the dia-
gram on the bottom of the battery compartment. Refer to
the illustration below.
Figure 2. Battery Compartment
• If the screen becomes too dim to view, the batteries need to be
replaced. Replace all four batteries to avoid unit malfunction.
When it is time to change the batteries, the
Data Holder
Feature
will save all Data and configuration information if fresh
batteries are installed immediately after removing the old ones.
CAUTION:
Leaving used or dead batteries in the EZ-Read beyond
S
ETUP
/ O
PERATING
I
NSTRUCTIONS
Page 7
Содержание EZ-READ
Страница 1: ...USERS MANUAL EZ READ REVISION 2 1...
Страница 36: ...Page 36 NOTES...
Страница 37: ...Page 37 NOTES...
Страница 64: ...Page 64...