AutoXray EZ-READ, Руководство пользователя

Страница: 19 / 64

Page 19
1. Run the engine until it is at normal operating temperature.
2. Make sure ALL electrical loads (blower fan, air conditioning,
radio, etc.) are OFF.
3. Connect the EZ-Read scanner cable to
the scanner and to the vehicle EEC-IV
computer connector, then press
POWER
todisplay the EZ-Read scanner opening screen.
4. Make sure the vehicle ignition key has been OFF for at least ten
seconds. Turn
the ignition key to start the engine, then press
SCAN
.
• Vehicles that support DCL will display a Scan menu. Make
sure
1-KOEO/KOER Scan
is highlighted, then press
ENTER
.
5. When the scanner is ready to scan the
vehicle,
ENTER to Scan
will be
displayed on the screen. Press
ENTER
to start scanning the vehicle
computer/sensors. (Pressing
SCAN
again will take
the unit out of Scan mode and display the opening screen.)
6.
Scanning Data
will be displayed
while the vehicle computer is scanned.
A normal scan can take up to five min-
utes.
• Vehicles equipped with a Power Steering Pressure Switch -
Turn the steering wheel 1/2 turn and release, when prompt-
ed.
• Vehicles equipped with a manual transmission - Push the
clutch in during the entire test.
• Vehicles equipped with 7.3 liter diesel engines - Press the
accelerator to the floor for the entire test.
S
CAN THE
KOER D
ATA
- F
ORD
(C
ONT
.)