5
ATOMIK-RC.COM
COPYRIGHT © 2012 ATOMIK RC
6
NOTE:
Please refer to the LiPO Battery instruction sheet and the LiPO Charger instruction manual that
came with your model for proper LiPO charging and safety guidelines.
Apply glue after assembling boat stand parts
BOAT STAND
BATTERY INSTALLATION
4
Thin CA Glue
2
1
3
Finished Stand
1. Slide control rod through
pivot block.
2. Apply thread lock and
tighten the set screw.
3. Make sure the servo is
centered before tightening
set screw.
INSTALLING THE RUDDER
Thread Lock
2.5mm
Hex Driver
3x3mm Set Screw
2
1
3
3x3mm Set Screw
Secure the hatch by aligning it over the three magnets. The hull magnet pockets are designed so the hatch will easily
drop into place and the magnets key into place. A molded lip around the perimeter of the motor compartment is
designed so water will drain away from the compartment. For added water protection, use strips of clear tape to seal
the lid on all four sides.
INSTALLING THE HATCH
Slide the prop onto the drive shaft making sure to align the notch with the drive dog. Use the supplied lock nut to secure
the prop to the propshafts. Use caution when installing the prop as it may have extremely sharp edges.
If you are using a
aftermarket prop, make sure it is sized for a 3mm prop shaft. If you are not using a 3mm prop, you will need to shim the
prop shaft or use an adapter to increase the diameter to .118 inch.
INSTALLING THE PROPELLER
2
1
