3
ATOMIK-RC.COM
COPYRIGHT © 2012 ATOMIK RC
4
Install 8 AA Batteries
CHARGER
0657 Venom Pro Charger
Thin CA Glue
Curved Scissors
Needle Nosed Pliers
Side Cutters
Thread Lock
LiPO BATTERY PACKS
See included VR2T manual for detailed instructions.
RECOMMENDED BATTERY PACKS
15033 40C 3S 2200mAh 11.1V LiPO - UNI
15037 50C 3S 2200mAh 11.1V LIPO - UNI
AA BATTERIES
1521 AA Rechargeable NiMH
ECOAA4 AA Alkalines (4pcs)
ECOAA8 AA Alkalines (8pcs)
x8
For Radio
x8
1.5mm
2.0mm
2.5mm
Hobby Knife #11 Blade
Screwdriver
No.2
No.1
Nut Driver
5.5mm
Hex Driver
REQUIRED ITEMS
THE RADIO
ON/OFF SWITCH
STEERING TRIM
STEERING DUAL RATE
ANTENNA
THROTTLE TRIM
THROTTLE
STEERING
WHEEL
RECOMMENDED ITEMS
ESC SETUP
FEATURES
2 pole(240,000rpm), 4 pole(120,000rpm), 6 pole(80,000rpm)
8 pole(60,000rpm), 12 pole(40,000rpm), 14 pole(34,000rpm)
TOGGLE BRAKE/NON-BRAKE MODE
Atomik™ 50A Pro Marine
Brushless Speed Control
Continuous Current: 50A
Burst Current (10S): 60A
BEC Mode: Switch
BEC Output: 2A/5V
Battery Cells: LiPO: 2-4
Weight: 1.27 oz (36 g)
Water-Cooling Pipe Dia: 5mm
Size L*W*H*: 46 x 27 x 16 mm
• Linear and smooth throttle response.
• Supports multi-pole and high KV brushless motors, perfect low speed control, and auto-detect
motor timing.
• Low voltage cutoff (LVC) to avoid over-discharge of battery and thermo protection to prevent ESC
from overheating.
• Simple to use, brake mode is easily programmable.
• High quality MOS-FET, low resistance, high efficiency, less heat and more durable.
• Waterproof plastic case.
1) Connect motor and receiver to the ESC.
2) Set the trigger to max throttle then turn on the transmitter.
3) Plug in battery to ESC.
4) After 4 high pitched tones, set the trigger to minimum throttle.
5) After 3 repeat monotones, disconnect battery from ESC.
6) Now the braking is turned on. To change brake setting again, repeat above procedures.
• Thermo protection will shut ESC down if temperature reaches above 120˚ C.
• Low Voltage Cutoff (LVC) auto detects at 3V per Cell.
SPECIFICATIONS
MOTOR RPM LIMIT
PROTECTION FEATURES
The water-cooled Atomik™ 50A Pro Marine Brushless Speed Control that came in your Atomik™ Whiplash
24” P1 RTR Electric Boat is pre-programmed from the factory. If you need to re-program it, please follow the
instructions below.
