Atex AR950, Руководство по эксплуатации

Страница: 27 / 106

20
25
25
10
10
ＳＴＯＰ
ＳＴＯＰ
Function of Each Part
Name and Function of Each Part
■
Ignition Switch
Ignition switch is used to start and stop the engine.
position --- When the ignition switch is in this position,
the engine stops and the ignition key
can be removed or inserted.
position --- The engine is running when the ignition switch
is in this position.
position --- Turning the ignition switch in this position to
start the engine. When released, the switch
automatically returns to the “ ” position.
● If the machine will not be used for a while and will remain in storage, be sure to remove the ignition key.
● Refer to p.30~33 of this manual for information on starting and stopping the engine.
■
Throttle Lever
The throttle lever is used to raise/lower the engine
speed.
The maximum horsepower (power) is available at the
maximum engine speed.
In the Eco-drive mode, the engine speed drops to the
level at which the amount of fuel is economically
consumed and the Eco-lamp remains lit. Since the
horsepower decreases by 10% compared to horsepower
at full-throttle, use the Eco-drive mode as necessary
according to the load. (Refer to p.45 of this manual)
■
Choke
Pulling the choke lever closes the choke valve, while
returning it opens the valve. Pull the choke when starting
the engine(in case of cold start, etc.) and be sure to
returning it once the engine has started. (Refer to p. 32 of
this manual)
ＳＴＯＰ
Ignition switch
ＳＴＯＰ
Throttle lever
Eco-lamp
Low
Hight
Choke