ASTRO ATS-9800, Руководство оператора

Страница: 28 / 36

SECTION 3
OPERATING THE TABBER
28
Tab Fold Position Adjustment
Adjust tab fold position by using the knob located on the Media Sensor Assembly.
1. Adjust for the desired media transport speed. See "Media
Transport Speed Adjustment".
IMPORTANT
The desired transport speed must be set before
adjusting the tab fold position. If the transport speed
is changed after adjusting the tab fold position, the
tab fold position will also change.
2. Start with the Tab Fold Adjustment Knob turned
fully clockwise.
Do not over-tighten!
3. Press the TAB Button so it is illuminated.
4. Place a couple of media pieces into the Hopper.
5. Press the Feed Button. The unit will feed and tab
both pieces of media.
6. Stop the unit by pressing the Feed Button again.
7. Check the tab fold position on the second piece.
8. If you are not getting enough tab on the top side of the
media, to provide the desired 50/50 fold; turn the Tab
Fold Adjustment Knob counterclockwise, about 1/4 turn.
9. Repeat Steps 4-8 until you achieve the desired tab fold.
10. Once you are satisfied with the tab fold position, you are
ready to begin tabbing.
Operating Sequence
1. Turn Main Power Switch ON.
2. To zero out the Job Counter; press the reset button on the Job Counter, located on
the top of the Tabber.
3. Set the desired transport speed.
4. Activate the Tab Button (
button will illuminate
)
5. Press the Feed Button (
button will illuminate
) to start the media feeding.
6. To Stop the Tabber, press the Feed Button again.