ASTRO ATS-9800, Руководство оператора

Страница: 10 / 36

SECTION 2
ASSEMBLY
10
4. Attach the Tab Box Tray. Hooks on the
Tab Box Tray fit over the upper shaft, at the
exit end of the Tabber, as shown. The Tray
hangs off the exit end of the Tabber.
5. Proceed to "Choosing a Location" .
In-Line Mode
Note: This process assumes you are using the system as an "in-line" Tabber.
1. If installed; remove the Rear Paper Support
from the Tabber. Remove the two
thumbscrews and washers shown.
Note: Reuse the thumbscrews and washers
to install the In-Line Guide Assembly,
shown later in this procedure.
2. If installed, remove the Material Guide
Assembly from the Tabber as shown.
Loosen the two thumbscrews that secure
the Assembly to the side wall as shown.
3. Remove the Assembly from the Tabber.
Tighten the thumbscrews into the side walls
of the Tabber for safe keeping.