ASTRO ATS-9800, Руководство оператора

Страница: 18 / 36

SECTION 3
OPERATING THE TABBER
18
6. Thread the tabs under the small shaft at the top of the Tab Drive
Assembly. Pull about 18 inches of tab stock out of the front of the Tab
Drive Assembly.
Verify Proper Tab Stock Orientation:
Tabs must be located on the front side of the stock,
as shown. If the tabs are located on the back of the
stock, then you must remove the tabs from the
unit, remove the tab box from the Tray and turn it
around 180 degrees. Restart process from
Step 1 .
7.
Thread tabs under the Peel Bar and out of the
other side of the Tab Drive Assembly, as shown.
8.
Position tab stock so the center hole in tab is
aligned with red dots on Tab Drive Assembly.