ASTRO ATS-309, Руководство оператора

Страница: 33 / 100

OPERATING TABBER
29
5. Press STOP key [7] (
located below soft keys
) to stop Tabber. Pressing large Emergency
Stop button [5] shuts down entire Tabber and locks out other keys. To restart from an
Emergency Stop, release button by turning it clockwise. Then press RUN key [8] to
restart Tabber.
IMPORTANT
TABBER IS EQUIPPED WITH A TIME-OUT FEATURE. IF TABBER IS LEFT
RUNNING WITHOUT FEEDING PIECES FOR MORE THAN 30 SECONDS, IT
SHUTS DOWN. TO RESTART, PRESS RUN KEY.
Understanding Start-up Screen
1. Start-Up screen (
at right
) appears.
Soft keys at bottom of display control
these functions:
a. Job #
–
Used to select one
of four programmable jobs.
More information can be
found under
“
Programming
Job
”
section.
b. Pass-Thru/Operate
–
When Pass-Thru is showing, Tabber will tab pieces as
they are fed through it. Pressing this soft key takes Tabber out of tabbing mode
and puts it in
Pass-Thru mode. In Pass-Thru mode, display will show Operate .
When Operate is showing, motor and main drive belts of Tabber will run, but
Tabber will not tab. This mode is used when Tabber is in-line with other
equipment and user does not want to tab the pieces going through Tabber.
c. Advanced
–
Pressing this key places Tabber in Advanced mode. This mode is
used to select Automatic Tab Sensing program and to access more information
regarding soft key menus.
2. Press RUN key (
on Control Panel below soft keys
) to start Tabber. Adjust Speed
Control to set Tabber speed. Press STOP key (
located below soft keys
) to stop Tabber.
Pressing large Emergency Stop button shuts down entire Tabber and locks out other
keys. To restart from an Emergency Stop , release button by turning it clockwise. Then
press RUN key to restart Tabber.
When Tabber is running, screen
at right appears. It contains the
following information:
a. Number of the programmed job
that is running.
b. Number of tabs being applied to
the piece by both heads.