Arthrex Angel, Руководство оператора

Страница: 92 / 108

Routine Care
6-6
Angel ® cPRP System Operator’s Manual
Figure 6-5 Removing the Pump Rotor
2. After cleaning and disinfection processes (detailed below), reinstall the pump into the rotor
housing by pushing down and turning the rotor clockwise.
Figure 6-6 Installing the Pump Rotor
CLEANING
1. Use a clean, low-linting cloth dampened with cold tap water to wipe away gross soil from the unit,
ensuring that the water flows over all affected areas.
2. Use a soft-bristled brush dampened with cold tap water to loosen any visible soil for one minute.
3. Prepare a neutral-pH enzymatic detergent solution. Ensure the instructions of the detergent
manufacturer regarding use-concentration and temperature are followed. It is recommended to use a
neutral-pH enzymatic detergent with given material compatibility.
4. Use a soft-bristled brush dampened with the detergent solution to remove remaining visible soil for a
minimum of one minute.
5. Use a clean, low-linting cloth dampened with the detergent solution to wipe all surfaces of the unit for a
minimum of one minute, ensuring that the detergent flows over all affected areas.
6. Use a clean, low-linting cloth dampened with cold tap water to wipe all surfaces of the unit in order to
remove detergent residues.
7. Check all surfaces for visible soil. Repeat cleaning steps if soil is visible and re-inspect.
PRECAUTION
When cleaning the Platelet Sensor, Centrifuge Lid and Touchscreen areas, use a neutral-
pH enzymatic detergent. Do not use bleach, abrasive materials or solvents, as they may
cause damage to the sensor.