Arkon MAGB2, Руководство пользователя, Страница: 8 / 54

MAGB2 User Guide 7 V1.7 2021-10-01
2.4. Installation of the transmitter
In case of a compact flowmeter version, the transmitter will need no further installation, and should be ready
for use.
In case of a remote version, the following 4 steps are necessary.

Mount the transmitter to a wall, panel, or DIN-rail.

Connect the transmitter to the signal cable from the sensor.
To do this undo four M6x22 screws using allen key nr.5 that is part of the delivery.
 After the meter is opened, pull the signal cable through the cable gland on the bottom of the transmitter
housing (see page 8). Connect the connector at the end of the signal cable from the sensor to the
transmitter circuit board.

Set up the transmitter for use.
You are now ready to start using your flowmeter or to customize its settings as per your requirements. For
example;
- Set-up the measurement unit of flow-rate displayed, e.g. m3/hr.
- Set up of the unit for the volume displayed. For all volume counters this same unit will be used.
Electrical installation should only be performed by a qualified person. Standard safety
regulations for hazardous electrical installations have to be respected.
The O-ring sealing shall be exchanged every 6 months of operation.
Wall
mounting:
DIN-rail
mounting:
The electronics
have to be
protected against
direct sunlight and
high temperatures!
The transmitter
housing should be
exposed to minimal
mechanical strain only
(max. 1kg)!
Panel
mounting: