ARIS TENSOR, Оригинальное учредительное заявление с ручным управлением

Страница: 13 / 32

13 Tensor
In case of loss of the mains voltage the MENU LED goes out. After saving the sensor
position all LED lioght until the final loss of the operating voltage. The motor is immediately
switched from the holding current in to the STOP mode.
5.2 Programming the end positions (Setup mode)
1. In manual mode, press the MENU button for >5s

the menu LED flashes 2x. Now the setup mode is active, the drive can
now be moved even over the pre-programmed limits.
2. Move the actuator to the left end position using the LEFT button. Hold buttons MENU and LEFT at once.

Left LED is
blinking. Hold buttons until the LED flashes permanently

the left end position is now saved.
3. Move the actuator to the right end position using the RIGHT button. Hold buttons MENU and RIGHT at once.

Right LED is
blinking. Hold buttons until the LED flashes permanently

the right end position is now saved.
• Quit the programming mode by switching to AUTO mode or by cutting the supply voltage.
• Now the actuator moves only between the programmed end positions.
Left and right end position can be reversed, the allocation of the directions of rotation of
the inputs 2/3 and the switch LI/RE does not change as a result.
• The multi-turn positions are automatically detected and stored with the end positions.
ADVICE
!
ADVICE
!
Motor rotates left
End position reached or override
Supply voltage ON
Setup mode active
Motor rotates left
End position reached or override
ON: Automatic active
OFF: Hand mode active
Current limit active at motor LI/RE
no error
Holding current active at motor STOP
Sensor error
Motor error
Status changing every second
Microcontroller in funtion and OK
ON
2x blink
ON
2x blink
ON
2x blink
ON/OFF
ON
OFF
1x blink
4x blink
5x blink
ON/OFF
Meaning