Arctic Cat XC 450 2016, Руководство по обслуживанию

Страница: 63 / 120

62
ATV-1074
3. Zero the indicator and rotate the crankshaft slowly.
4. Maximum runout must not exceed specifications.

NOTE: Proceed to check runout on the other end of
the crankshaft by positioning the indicator contact at
point 2 and following steps 3-4.
Measuring Crankshaft
(Web-to-Web)
1. Using a calipers, measure the distance from the out-
side edge of one web to the outside edge of the other
web.
ATV-1017
2. Acceptable width range must be within specifica-
tions.
COUNTERSHAFT
Disassembling
1. Remove the reverse driven gear dog; then remove
the circlip securing the reverse driven gear.
FI663
FI664
2. Remove the splined washer; then remove the reverse
driven gear along with the bearing and bushing.
FI665
3. Remove the low driven gear washer; then remove the
low driven gear along with the bearing and bushing.
FI666
CAUTION
Care should be taken to support the connecting rod
when rotating the crankshaft.
CAUTION
When disassembling the countershaft, care must be
taken to note the direction each major component (dog,
gear) faces. If a major component is installed facing the
wrong direction, transmission damage may occur and/
or the transmission will malfunction. In either case,
complete disassembly and assembly will be required.