Arctic Cat XC 450 2016, Руководство по обслуживанию

Страница: 47 / 120

46
FI551A
10. Remove starter idler gears and their respective
shafts; then remove the starter motor. Account for an
O-ring on the starter drive housing.
FI555
G. Shift Shaft
H. Drive Gear
 NOTE: Steps 1-10 in the preceding sub-sections
must precede this procedure.
11. Remove the shift shaft noting a washer on each end;
then remove the cap screw securing the gear shift
cam plate and remove the plate from the shaft.
FI559
12. Remove the shift detent cam arm and spring.
FI560
13. Remove the snap ring securing the output drive gear
to the output shaft and remove the gear noting that
the hub flange is directed toward the crankcase.
FI564
FI566
Servicing Left-Side
Components
INSPECTING STARTER CLUTCH/GEAR
1. Place the starter clutch gear onto the rotor/flywheel
and attempt to rotate the starter clutch gear clock-
wise. It should lock up to the rotor/flywheel. Rotate
the gear counterclockwise and it should turn freely. If
it moves or locks up both ways, the starter clutch
must be replaced.
2. Inspect the starter clutch gear for chipped or missing
teeth or discoloration/scoring of the clutch surface.
Inspect the bearing for loose, worn, or discolored
rollers. If bearing is damaged, it must be replaced.