Arctic Cat XC 450 2016, Руководство по обслуживанию

Страница: 105 / 120

104
CD110
Removing Needle Bearing

NOTE: Removing the needle bearing is rarely nec-
essary. Avoid removing the needle bearing unless the
bearing is clearly damaged.

NOTE: This procedure can be performed on a rear
gear case.
1. Place a 1/4 in. drill bit on the inside surface of the
needle bearing (against the bottom side); then drill
through the pinion shaft needle bearing housing.
CC885
2. Using a propane torch, heat the area surrounding the
needle bearing to soften the Loctite.
CC886
3. Using a flat-nosed punch, drive the bearing out of the
housing.
CC887
Installing Needle Bearing
1. Apply green Loctite #609 to the outside of a new
bearing; then place the new bearing into the housing.
CC888
2. Using a suitable driver, install the needle bearing into
the gear case housing making sure the bearing is
seated.

NOTE: Do not push the bearing too far into the
housing.
GC045A
3. Install the pinion shaft and secure with a new 48 mm
lock collar. Tighten to 125 ft-lb.