Arctic Cat XC 450 2016, Руководство по обслуживанию

Страница: 113 / 120

112
PR719C
4. Install the caliper onto the caliper holder making sure
the caliper and holder are correctly oriented.
 NOTE: It is very important to apply silicone grease
to the O-rings and caliper bores prior to assembly.
PR239C
5. Making sure brake fluid does not contact the brake
pads, compress the caliper holder toward the caliper
and install the inner brake pad; then install the outer
pad.
PR238
PR239
6. Place the brake caliper assembly into position and
secure with new “patch-lock” cap screws. Tighten
the caliper to 20 ft-lb.
7. Place a new crush washer on each side of the brake
hose fitting and install it on the caliper. Tighten to 20
ft-lb.
8. Fill the reservoir; then bleed the brake system (see
Periodic Maintenance/Tune-Up).
9. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque of 40 ft-lb (steel wheel), 60 ft-lb (aluminum
wheel w/black nuts), or 80 ft-lb (aluminum wheel w/
chrome nuts).
10. Remove the ATV from the support stand and verify
brake operation.
CAUTION
If brake pads become contaminated with brake fluid, they
must be thoroughly cleaned with brake cleaning solvent
or replaced with new pads. Failure to do so will result in
reduced braking and premature brake pad failure.
! WARNING
Never use brake fluid from an open container or reuse
brake fluid. Moisture-contaminated brake fluid could
cause vapor build-up (expansion) during hard braking
resulting in greatly increased stopping distance or loss
of control leading to injury or death.