Arctic Cat PROWLER HDX 2015, Руководство по обслуживанию

Страница: 189 / 192

186
Wheels and Tires
TIRE SIZE
This vehicle is equipped with low-pressure tubeless tires
of the size and type listed in the General Information sec-
tion. Do not under any circumstances substitute tires of a
different type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 1.41 kg/
cm² (20 psi).
REMOVING
1. Secure the vehicle on a support stand to elevate the
wheels.
2. Remove the nuts securing the wheels; then remove the
wheels.
CLEANING AND INSPECTING
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and
leaks.
INSTALLING
1. Install each wheel on its hub and secure with the exist-
ing hardware.
2. Tighten in 20 ft-lb increments to 40 ft-lb (steel
wheel) or 80 ft-lb (aluminum wheel).
CHECKING/INFLATING
1. Using an air pressure gauge, measure the air pressure
in each tire. Adjust the air pressure as necessary to
meet the recommended inflation pressure.
2. Inspect the tires for damage, wear, or punctures.

NOTE: If repair is needed, follow the instructions
found on the tire repair kit or remove the wheel
and have it repaired professionally.

NOTE: Be sure all tires are the specified size and
have identical tread pattern.
! WARNING
Use only Arctic Cat approved tires when replacing tires.
Failure to do so could result in unstable vehicle opera-
tion.
! WARNING
Always use the size and type of tires specified. Always
maintain proper tire inflation pressure.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the vehicle and could
cause excessive drive train damage not covered by war-
ranty.
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
! WARNING
Do not operate the vehicle if tire damage exists.