Arctic Cat PROWLER HDX 2015, Руководство по обслуживанию

Страница: 15 / 192

12
6. Start the engine (while the vehicle is outside on level
ground) and allow it to idle for a few minutes.
7. Turn the engine off and wait approximately one minute;
then unscrew the oil level stick and wipe it with a clean
cloth.
8. Install the oil level stick and thread into the engine case.
9. Remove the oil level stick; the oil level must be within
the operating range but not exceeding the upper mark.
GZ461A
10. Inspect the area around the drain plug and oil filter for
leaks.
Front Differential - Rear
Drive Lubricant
To check lubricant, use the following procedure.
1. Remove the level plug (B); the lubricant should be
level with the bottom threads.
HDX221A
2. If low, remove the fill plug (A) and add the appropriate
lubricant until it appears at the bottom of the level plug
threads.
To change the lubricant, use the following procedure.
1. Place the vehicle on level ground.
2. Remove each fill plug.
3. Drain the lubricant into a drain pan by removing in turn
the drain plug from each.
HDX255
HDX220A
4. After all the lubricant has been drained, install the drain
plugs and tighten to 45 in.-lb.
5. Pour the appropriate amount of recommended lubricant
into the fill hole.
6. Install the fill plug and tighten to 16 ft-lb.

NOTE: If the lubricant is contaminated with water,
inspect the drain plug, fill plug, and/or bladder.
Driveshaft/Coupling
The following drive system components should be
inspected periodically to ensure proper operation.
A. Spline lateral movement (slop).
B. Coupling cracked, damaged, or worn.
C. Universal joints worn or missing bearings.
Nuts/Bolts/Cap Screws
Tighten all nuts, bolts, and cap screws. Make sure rivets
holding components together are tight. Replace all loose
rivets. Care must be taken that all calibrated nuts, bolts,
and cap screws are tightened to specifications.
CAUTION
Do not over-fill the engine with oil. Always make sure
that the oil level is not above the upper mark.