Arctic Cat PROWLER HDX 2015, Руководство по обслуживанию

Страница: 168 / 192

165
CD027
5. Install the wheel. Tighten in 20 ft-lb increments to 40
ft-lb (steel wheel) or 80 ft-lb (aluminum wheel).
6. Remove the vehicle from the support stand and
release the parking brake.
INSTALLING FRONT DRIVE AXLE
1. Push the axle shaft into the CV coupler to release the
lock ring; then position the drive axle in the gear case
and steering knuckle; then insert the ball joints into
the steering knuckles. Secure with cap screws tight-
ened to 35 ft-lb.
2. Secure the lower shock eyelet to the A-arm with a
cap screw and a new lock nut. Tighten to 20 ft-lb.
3. Slide the hub w/brake disc into position in the steer-
ing knuckle followed by a hex nut. Finger-tighten at
this time.
4. Install the brake caliper on the steering knuckle using
new “patch-lock” cap screws. Tighten to 20 ft-lb.
5. Place the transmission in park; then turn the ignition
switch to the ON position, select LOCK on the drive
select switch. Turn the ignition switch to the OFF
position.
6. Tighten the hex nut (from step 3) to 200 ft-lb; then
install and spread a new cotter pin making sure each
side of the pin is flush to the hub nut.
CD027
7. Install the wheel and tighten in 20 ft-lb increments to
40 ft-lb (steel wheel) or 80 ft-lb (aluminum wheel).
8. Remove the vehicle from the support stand.
9. Check the front differential lubricant level and add
lubricant as necessary.
PR065A
Rear Gear Case
REMOVING

NOTE: Release the cargo box latch and allow the
cargo box to tilt back; then remove the cargo box lift
support by removing the cap screw and nut securing
the lower lift support to the frame. The cargo box will
tilt fully rearward.
1. Drain the lubricant from the rear gear case; then
remove both rear drive axles.
2. Remove the driveline brake caliper; then cut the rear-
most propeller shaft boot clamp and slide the boot
forward.
3. Remove the boot clamps on the rear driveline boot.
4. Remove the two cap screws and lock nuts securing
the rear gear case to the frame; then remove the gear
case through the upper left-side of the frame and lift
out the top.
PR207

AT THIS POINT
For servicing the input shaft, pinion gear, needle bear-
ing, ring gear, and axle seal, see Front Differential in
this section.