Arctic Cat PROWLER HDX 2015, Руководство по обслуживанию

Страница: 109 / 192

106
CF366
CF379

NOTE: At this point, the cap screw can be removed
from between the driven pulley faces.
17. With the vehicle in neutral, rotate the V-belt and
clutches counterclockwise until the V-belt is flush
with the top of the driven pulley.
18. Place the V-belt cover gasket into position; then
install the cover and secure with the cap screws mak-
ing sure the different-lengthed cap screws are in their
proper location. Tighten the cap screws to 8 ft-lb.
CF363
Center Crankcase
Components

NOTE: This procedure cannot be done with the engine/
transmission in the frame. Complete Removing proce-
dures for Top-Side, Left-Side, and Right-Side must pre-
cede this procedure.

NOTE: For efficiency, it is preferable to remove and dis-
assemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
Separating Crankcase
Halves
1. Remove the right-side cap screws securing the crankcase
halves. Note the location of the different-lengthed cap
screws.
2. Remove the left-side cap screws securing the crankcase
halves. Note the location of the different-lengthed cap
screws.
3. Using the Crankcase Separator/Crankshaft Remover and
tapping lightly with a rubber mallet, separate the crank-
case halves. Account for two alignment pins.

NOTE: To keep the shaft/gear assemblies intact for
identification, tap the shafts toward the left-side crank-
case half when separating the halves.
PR786
Disassembling Crankcase
Half

NOTE: For steps 1-7, refer to illustration PR787A.

NOTE: To aid in installing, it is recommended that
the assemblies are kept together and IN ORDER.
CAUTION
Make sure the movable drive face plate is fully engaged
onto the splines of the clutch shaft before tightening the
nut or false torque readings may occur. This will cause
the assembly to loosen damaging the shaft and clutch
face plate.