Arbiter Systems 931A, Руководство по эксплуатации

Страница: 104 / 161

for the Model 931A, match those of the host computer (refer to
Section 3.3.1.13).
3. Configure the communications software in the host computer to
receive binary files using the XMODEM protocol. Enable the
communications software for reception of the file by assigning a file
name with the extension BMP.
4. Set the Model 931A to make the desired measurement, or select
a stored data record and configure the Model 931A to display the
desired data.
5. Press the PRINT key and wait for the prompt message to disappear.
At this point, the Model 931A suspends normal operation waits for
the host computer to initiate the transfer. Use the ESCAPE key to
abort the transfer and resume normal operation.
It takes several seconds for the Model 931A and the host computer to
establish communication and begin the transfer.
3.11.5 Spreadsheet
Use this mode to import data directly into spreadsheet programs. Data is
comma and quote-delimited; commas separate all data fields (number and
text), with text enclosed in quotes.
The type of exported data depends on which operating mode the Model
931A is set for at the time the PRINT key was pressed. Firmware outputs
all spreadsheet data as ASCII text. The following paragraphs provide a
breakdown of the different data types, and their corresponding formats.
3.11.5.1 Standard Data
The Model 931A exports standard data with each press of the PRINT key.
Export data either while performing measurements or reviewing stored
data in one of the following modes of operation:
Volts/Amps Phase/Frequency Power/Vars
VA/PF Timer Transducer
CH1/CH2
Standard data is exported with the following format: log data #,
date, time, min/max/average/normal, CH1 select, CH1 dc/rms/mag, CH2
select, CH2 dc/rms/mag, phase, frequency, power, vars, VA, PF
88