Arbiter Systems 931A, Руководство по эксплуатации

Страница: 136 / 161

Add 4 to each of the numbers above to disable the Lead/Lag indication
on the Power Factor Display.
A.3.42 Range, Set (SRG)
Command:
rng#,ch#SRG
Used to set the analog input range. After the range is set, puts the selected
channel into Range-Hold Mode. Use the ch#RRH command to release
Range-Hold. The approximate input ranges are as follows:
Rng# AC Voltage AC Current DC Voltage
0 0 – 3.5 0 – .09 0 – 5
1 3 – 7 0.8 – 0.18 4.2 – 10
2 6 – 14 0.16 – 0.37 8.5 – 20
3 12 – 28 0.32 – 0.75 17 – 40
4 24 – 56 0.64 – 1.49 34 – 80
5 48 – 112 1.28 – 2.98 68 – 160
6 96 – 224 2.56 – 5.97 135.8 – 320
7 192 – 448 5.12 – 11.9 271.5 – 640
8 384 – 750 10.24 – 20.0 543 – 1000
ch# To Select
1 Channel 1
2 Channel 2
A.3.43 Scale Factors, Set or Return (SSC)
Command:
in#,m#,p#,s/r#SSC
Set or return calibration factors to be applied to each input function,
such as for CT or PT corrections. Scale factors consist of a magnitude
correction, which is a ratio (or p/u) number; and a phase angle, in degrees.
Multiplies the measured result by the magnitude correction and adds the
phase angle.
in# – specifies the input signal configuration, as follows:
120