CHAPTER 4
REMOTE CONTROL PROGRAMMING
Entire Contents Copyright
2014 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
44M04 LOAD MAINFRAME OPERATIONS MANUAL
Page 55 of 93
44M00
4.6
Remote Control Command Descriptions
The remote control syntax of all available commands is described in the following sections.
Supported commands are grouped in the following categories:
Command Category
Description
SETTING
Setting commands are used to program operating modes,
sink values and built in test modes like SHORT, OPP and
OCP. This category also contains specific commands that
apply to the 41D/42D LED Load modules.
LIMIT
Limit commands may be used to set expected upper and
lower operating limits as they apply to a unit under test.
These limit settings are used in conjunction with Go/No-go
testing to indicate the load is sinking outside expected
parameters.
STATE
State commands are used to query or clear status
information from a load module to determine its operating
condition.
SYSTEM
System commands enable querying of load module model
number and configuration data, RS232 control on/off. They
also support storing and saving load set-ups in non-volatile
memory of the 44M04 mainframe. (15 Banks / 10 States)
MEASUREMENTS
Allows querying load measurement data.
