RAIDER
2000
-
18
-
OPERATOR FOR SWING GATES
English
L
a
Preparation of the rear mounting
2.4
Estimate
B
measurement for securing the operator to
the installation
(Fig.6 and Tab.1)
.
With
this
B
value, calculate the length (
L
) for the rear
mounting as follows:
L = B-Y
. Assemble the two plates that
comprise the mounting to reach the length calculated
(see
example in
Fig.7
)
.
The possible mounting assemblies are shown in
Fig.8
and each
one is noted with its corresponding length.
Secure the plates with the screw and nut pairs
supplied.
Next, use a hacksaw to cut the operator securing plate
just behind the hole used.
L = 55 mm
L = 65 mm
L = 98 mm
L = 80 mm
L = 110 mm
L = 90 mm
x
x
Y
Fig.9
Fig.7
2 screws 8x25 UNI5739-8.8
ZN-B screws (included in
the kit)
2 self locking nuts M8
UNI 7473-6S ZN-B
(included in the kit)
Important
- In order to calculate the most suitable length of
the mounting (
L
) for your installation, you should decide on
the assembly position of the two plates (always use the
x
hole + one of the 5 arranged in an arc) and choose the hole
for securing the operator from one the 2
Y
holes provided.
Fig.8
do not use
this hole
Making a niche on the masonry pillar for rear mounting
2.5
It may be necessary to make a niche in the masonry pillar for the rear mounting of the operator. Use
Fig.9
as a guide to
estimate the niche size.
MAX. from the inge axis to the plate surface
60
180 min.
50
150
1250
Y
B
A
50
150 min.
Y
B
A
