Apollo Seiko J-CAT200 COMET, Руководство по эксплуатации

Страница: 28 / 60

Page 28 of 60
13. Easy Slide Soldering Program Setting
13.1 Easy Slide (Line) Soldering flow
The flow of easy slide soldering as follows:
*When the soldering feed/ Rev. amount is “0”, it is jumped to next soldering condition.
Name Description
1st solder amount
/ feed speed
Set 1st solder amount and feed speed.
With the iron tip being up, the solder wire feeds to the iron tip.
By feeding a few solder wire to the iron tip, the heat can quickly transfer to the
joint area.
The setting value depends on the joint / substrate and the type of iron tip.
1st solder Rev. amount
/ Rev. speed
Set the amount and speed to retract the solder wire after 1st solder feeding.
The purpose of the 1st solder Rev. is to prevent the solder wire from melting by
the heat of iron tip. Also the next solder amount can accurately feed by
retracting the solder wire.
Pre-heat time
Set the time that the iron tip goes down and heats the joint substrate.
Pre-heat time depends on the size of joint/ substrate.
Start pool time
It is the solder pooling time before sliding start. The sliding stats after the set
pool time.
2nd solder feed speed
Set 2nd solder feed speed that the joint requires.
The feeding amount is decided by 2nd solder feed speed and the time that the
iron tip moves from the start point of Easy Line Soldering to the end point.
Although 2nd solder amount depends on the joint, 1st solder Rev. amount also
needs to be considered.
End pool time It is the solder pooling time after slide finishing.
2nd solder Rev. amount
/ Rev. speed
Set the amount and speed to retract the solder wire after 2nd solder.
In the same way of 1st solder Rev, the next solder amount can accurately feed
by retracting the solder wire.
Heating time
It is the heating time after solder feeding and slide finishing.
It depends on the size of joint / substrate.
13.2 Easy Line Soldering Teaching
Refer to 12.2 Slide (Line) Soldering Teaching and follow the same procedure.
①
*
1st solder
②
Pre-heat
③
*
2nd solder
⑤
Heating
④
*
2nd solder Rev.
Timer: Pre-heat time
Soldering
condition
：
Robot speed
XY ：
Line speed
Start
pool
time
Heating
time
2nd solder
feed speed
End
pool
time