Apollo Seiko J-CAT200 COMET, Руководство по эксплуатации

Страница: 21 / 60

Page 21 of 60
F4
Point Solderting Condition Entry Screen
When you press VIEW when entering Soldering condition number, the following Soldering
condition entry screen appears.
Select the each condition that is necessary to the point where you did Teaching by CURSOR key,
then press ENTER
→ Input value → ENTER for register.
After entering necessary value, the screen returns to Soldering condition number entry screen by
ESC key.
Press ENTER.
“Point soldering” point has been registered and the next point
screen is displayed.
*Soldering condition can be also enterd in “Soldering condition” by pressing MENU key at Teaching
mode.
Soldering Condition 1 1/2
Soldering Type Point Soldering
1st Amount 7mm
1st Feed Speed 15mm/s
1st Rev. Amount 3mm
1st Rev. Speed 50mm/s
Pre-Heat Time 0.5sec
2nd Amount 7mm
2nd Feed Speed 10mm/s
2nd Rev. Amount 3mm
2nd Rev. Speed 50mm/s
Heating Time 0sec
3rd Amount 0mm
Soldering Condition 1 2/2
3rd Feed Speed 10mm/s
3rd Rev. Amount 0mm
3rd Rev. Speed 50mm/s
Enter a number
Condition Number 1
DEL COPY NEW LIST VIEW
Program1 P2
X 0mm
Y 0mm
Z 0mm
R
0deg
FUNC JOG MDI
INIT