Apollo Seiko J-CAT200 COMET, Руководство по эксплуатации

Страница: 20 / 60

Page 20 of 60
11.2 Point Soldering Teaching
Using JOG key to move iron cartridge until “Point Soldering”
point.
Press ENTER .
Select the type “Point Soldering” by CURSOR key.
Press ENTER .
Enter condition number 1-100.
Note: 100 conditions can be selected. Do not enter the
same number as the slide soldering condition.
DEL: Deletes soldering condition.
COPY: Copies soldering condition.
NEW: Displays the list of unset soldering condition
number.
LIST: Displays the list of set soldering condition number.
VIEW: Shows the soldering condition of the displayed
number.
*Refer to the next page.
*If the solderting condition is not set,
initial value is displayed.
* The programmed solderting condition number can be used in the other point soldering program.
F0
F1
F2
F3
F4
F0 F1 F2 F3 F4
Program1 P1
X 0mm
Y 0mm
Z 0mm
R
0deg
FUNC JOG MDI
INIT
Select Point Type 1/4
Point Soldering
Point Soldering (No Up)
Start of Line Soldering
Line Passing
Arc Point
End of Line Soldering
Start of Easy Line Soldering
Easy Line Passing
Arc Point
End of Easy Line Soldering
Pre Solder
Cleaning Point
Enter a number
Condition Number 1
DEL COPY NEW LIST VIEW