Apollo Seiko J-CAT200 COMET, Руководство по эксплуатации

Страница: 18 / 60

Page 18 of 60
X
X
Y
Y
Z
Z
R
R
T.ENV
MODE SAVE GO
EDIT
ESC MENU
DEL
ENTR
1 2 3
4 5 6
7 8 9
.
0
SHIFT
CTRL
10. Teaching Pendant Basic Key Operation

In the Teaching Mode
Soldering is operated with the iron staying at the lower position.
While teaching the soldering position, check the position with the iron down key “1” or “0”.
 At the setting screen that displays the programmed coordinate
: Used to switch the screen to previous / next screen.
: The axes move to the coordinate value of the displayed current screen.
: The axes move to the coordinate value of the displayed current screen and operates
the programmed point job.
+ : Used to move the axes to the home position.
By F2 and F3 keys, the mode can be switched between JOG and MDI Mode
One Touch Feed Length
Refer to Soldering System
Setting page.
By pressing and holding,
solder wire is fed in reverse.
JOG Keys
Used to move 4-axis in the
JOG Mode*1.
By pressing and holding, air-
blowing
By pressing and holding, Iron
goes down and stays at lower
position.
By pressing once, Iron goes
down.
By pressing and holding,
solder wire is fed.
By pressing once, Iron goes
up.
GO
F4
GO SHIFT
Program1 P1
X 122mm
Y 151.2mm
Z 59.1mm
R
0deg
FUNC JOG MDI
INIT
Program1 P1
>X 122mm
>Y 151.2mm
>Z 59.1mm
>R 0deg
FUNC JOG MDI
INIT
JOG Mode *1
In the JOG Mode, move the arms to the
setting position by JOG keys.
MDI Mode
In the MDI Mode, enter the setting
coordinate value by the numeric keys.
The arms does not move in the MDI
Mode.
F0 F1 F2 F3 F4
F0 F1 F2 F3 F4