4
2
Fixed Station Operation
♦
In order to use this transceiver for fixed station 1 operation, you will
need a separate 13.8 V DC power supply (not included).
The recommended current capacity of your power supply is 12 A.
Connect the DC power cable to the regulated DC power supply
12
and ensure that the polarities are correct (Red: positive, Black:
negative).
Do not directly connect the transceiver to an AC outlet.
•
Use the supplied DC power cable to connect the transceiver to
•
a regulated power supply.
Do not substitute a cable with smaller gauge wires.
•
Regulat Power supply [QRP-01]
Red Lead
Black Lead
Replacing Fuses
♦
Connect the transceiver's DC power connector to the connector
22
on the DC power cable.Press the connectors firmly together until
the locking tab clicks.
Note:
Before connecting the DC power to the transceiver , be sure to
switch the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you make
all connections.
If the fuse blows, determine the cause, then correct the problem.
After the problem is resolved, replace the fuse. If newly installed fuses
continue to blow, disconnect the power cable and contact your autho-
rized dealer or an authorized service
center for assistance.
PREPARATION
