13
6
SHORTCUT OPERATIONS
FUNC
FUNC
FUNC
FUNC
FUNC
SCAN
ENTER
ENTER
CALL
CALL
CALL
V/M
SQ/C
Channel Name Edit
Short Call
CTCSS/DCS Scan
Frequency/Channel Scan
When transceiver is in channel name display mode, after pressing
key, LCD displays "
FUNC
", then press key to get into the
channel name program mode of current channel. Turn channel
selector to select the desired character or figure, press key and
key to move the cursor, press key to confirm and exit when
finish program.
While standby, press key to transmit optional signaling(DTMF,
2-Tone, 5-Tone) in current channel.
In relevant modes, press key repeatedly until LCD displays
"
FREQ/CH SCAN?
", then press key to enable frequency/channel
scan.
Frequency Scan
♦
In frequency mode, this function is designed to monitor signal
of every communicative frequency point of transceiver “STEP”
you have set. Press Microphone [
UP/DOWN
] or selector knob to
change scan direction, press any key (other than key) to exit.
Note:
Note:
When the transceiver is programmed with PA frequency and PB
frequency, in frequency mode (VFO), frequency subsection scan
is valid. For details, please refer to help options in programming
software.
Channel Scan
♦
In channel mode, this function is designed to monitor signal in every
channel. Press Microphone [
UP/DOWN
] or the selector knob to
change scan direction, press any key (other than key) to exit.
Press key repeatedly until LCD displays "
CTCSS/DCS SCAN?
",
then press key to start scan. When finding a matching signaling,
the scan will pause for 15 seconds then scan again. Press any key
(other than key) to exit.
Invalid when no signaling existed in current channel.
When the current channel signaling is set to CTCSS, the tran-
sceiver will scan CTCSS.
When the current channel signaling is set to DCS, the transceiver
will scan DCS.
Press Microphone [
UP/DOWN
] or turn selector knob to change scan
direction.
