19
7
CHANNEL OPERATIONS
Signaling Combination Setup
SCAN
ENTER
Note:
5-Tone setup should be programmed by software, the transceiver
can only display the programmed group. If you edit each group with
a name , the name and number will both displayed when you check
5-Tone.
This function is used to setup squelch mode.
Press key to enter function menu.
12
Repeatedly press key or Microphone [
22
UP/DOWN
] key until
LCD displays "
SIGNAL
".
Turn selector knob to select desired signaling combination.
32
When LCD Displays:
"
SQUELCH
" indicates you can hear the calling as long as the
transceiver receives matching carrier.
“
CTCSS/DCS
” indicates you can hear the calling as long as the
transceiver receives a matching carrier and a matching CTCSS
or DCS signaling.
“
TONE
” indicates you can hear the calling as long as the
transceiver receives a matching carrier and a matching DTMF,
2-Tone or 5-Tone signaling.
“
CTDCS&TONE
”, you can here the calling as long as the
transceiver receives a matching carrier and a matching CTCSS or
DCS signaling and a matching DTMF, 2-Tone or 5-Tone signaling.
"
CTDCS/TONE
", you can here the calling as long as the transc-
eiver receives a matching carrier and any one of a matching
CTCSS,DCS, DTMF,2-Tone,5-Tone signaling.
Offset Direction Setup
This function should coordinate with the offset frequency setup,
which enable you to communication with another transceiver through
a repeater.
Press key to enter function menu.
12
Repeatedly press key or Microphone [
22
UP/DOWN
] key until
LCD displays "
OFFSET
"
SCAN
ENTER
“
OFFSET-
”, indicates transmitting frequency is lower than
receiving frequency. When Reverse Function is enabled,
Transmitting frequency is higher than receiving frequency.
Turn selector knob to select the desired offset direction.
32
