AnyNet AnyNet-12824, Руководство по эксплуатации системы

Страница: 191 / 195

191
Function description of the “HDD Health Checkup”:
Section 1:
HDD Information: Hard disk drives installed in your NVR.
Section 2:
HDD status: This section displays the current temperature of the selected hard disk drive, as well as
its health status level and surface sector defect factor.
Section 3:
Auto start : This ezHDDSmart program will automatically launch itself in the background when
Windows starts (when you turn ON your PC).
Checkup interval : Decide how often you would like ezHDDSmart to perform a scan check of your
installed hard disk drives to determine their reliability.
Auto-save logs : It will record the attributed factors of the defect on the view log table when checked.
Pop-up message
: The main NVR
application (Witness Pro) will pop up an
error message to notify any failures,
which could require your prompt
attention when checked. There are two
failure levels, “ dangerous ” and
“ warning only ”. Please respond to the error message in the following manner:
** Warning: It is highly recommended to back up your problematic hard disk on a regular basis to help
reduce data loss.
** Dangerous
: Failure Predicted! Please replace your hard disk drive immediately, or at least disable it in
the Storage Devices Configuration within Witness Pro.
Send e-mail : Any HDD error messages will be sent to you via email when checked.
E-mail setup : Type your email address to receive HDD error message notifications. Please follow the
steps below to set up email notification:
Step 1. Type the receiver’s e-mail address in the “ Add new e-mail address ” entry field.
Step 2. Fill both “ SMTP server ” and “ Port ” in the entry fields.
Step 3. Type the sending e-mail address in the “ From address ” entry field.