ANGELUS SANITARY CAN MACHINE COMPANY
SERVICE NOTICE
2
10/7/99-18020001
4th. Subtract the Pad contact dimension, .155 from the countersink dimension, .270
Equals:
.115
5th. Measure and add the Knockout Pad Offset
depth .160 of an inch to the above result.
Equals:
.275
6th. Add .080 of an inch to the
above result in step 5.
Equals:
.355 of an inch
7th. Add .355 to the Seamer Pin Height.
Example: 4.500 + .355 = 4.855
8th
Place each station at the Timing Pin located
on the Lower Turret Guard.
Adjust the Knockout Pad at all stations
to obtain 4.855 inches from the offset area
of the Pad down to the Lower Chuck Plate.
Secure 1/2-20 Jam Nuts securely.
9th
Adjust the Discharge side of the Knockout
Cam radially.
Rotate the Seaming Turret around, with a
seamed can and correct internal pressure, and
Adjust Knockout Pad height
stop at the point where the seamed can has
with an Inside Micrometer.
just released from the Seaming Chuck. Position
the Knockout Cam-Discharge radially until a .010 feeler gauge slips between the can and
Lower Chuck Plate. Secure the Cam.
NOTE:
Set Knockout Pads measuring from Lower Chuck Plate up to the Offset area of the Pad.
Set Knockout Pad height when each station is positioned at the Timing Pin located on the
Lower Turret Guard.
Check can and cover control during the rise up to the Seaming Chuck. When the cam
is adjusted correctly, one should not be able to lift the can and cover up away from
the Lower Chuck Plate during the entire duration or cam rise, but still be able to turn
the can freely without any binding or pressure from above.
Knockout Pad Offset measurement
equals .160 of an inch