ANGELUS SANITARY CAN MACHINE COMPANY
SERVICE NOTICE
5 of 5
Oil Refill Process.
Install all drain plugs (use pipe sealant) before refilling oil.
1.
Refill Upper Turret through the Rotating Union Guard on top of the
Machine. Pour the oil down the outside of the Rotating Union Support and
not down the center. Install (6) quarts of Aero-Shell W80 oil.
2.
Fill Lower Turret through fill plug. Install 8 quarts Aero-Shell W80 oil.
3.
Fill Drive Case through an opening on the side of the Base just below
Discharge side of Machine. Take off the Base Cover to do this. Drive Case
holds 21 1/2 quarts of Aero-Shell W80 oil.
4.
Filler Drive and In-Motion Timer Housings will hold 4 1/2 quarts Aero-
Shell W80 oil. Both these units can be filled at the same time through an
opening in the Filler Drive Clutch Housing.
5.
Fill Tail Shaft assembly with 1 quart of Aero-Shell W-80 oil. There is a fill
plug on top of this assembly.
5.
Refill Filler Drive Gear Case with 3 quarts of 80/90W Lubriplate. Fill
plugs are located on top of this assembly.
6.
Refill Trabon oil Reservoir with 7 quarts Aero-Shell W-80 oil.
7.
Refill Filter Canister with 6 quarts Aero-Shell W-80.
Note:
If Food Grade Oil is required then use Chevron FM105X. Tube lines
from the oil pump will consume a certain amount of oil. Listed are
quantities of oil per foot.
A 1/2" Tube line holds 0.04 quarts of oil / Foot.
3/4" line holds 0.1 qts./ft.
1.0" line holds 0.16 qts./ft.
