4.1.4.
Change Chart While Processing
1.
ÿýý
to initiate the chart Hold sequence
2.
Display will show:
CHART ROTATION
CONT HOLD NEW
3.
ÿ
FUNCTION KEY directly beneath HOLD
4.
Display will show:
CHART ROTATION
HOLD
5.
The chart is now in a Hold state. All current events are being recorded to memory.
6.
Place the NEW BLANK CHART onto the AV-9900 at this time - proceed to step 7 to re-start
chart.
7.
ÿýý
to initiate the Chart New sequence
8.
Display will show:
CHART ROTATION
CONT HOLD NEW
9.
ÿ
FUNCTION KEY directly beneath NEW
10.
ÿú
to retun to normal display
11.
A new chart will begin to print. Data, from the time Chart Hold was initiated, is being recorded
to memory. Chart will begin printing at an accelerated speed until all data and events have been
transfered from memory to the chart, and real time has again been reached.
4.2.
How Do I Change an STLR Diversion Setpoint
Up to five STLR diversion setpoints may be pre-programmed into the AV-9900 (See section 5.4.1). If
only one setpoint is programmed (single divert), the option as described below will not apply. Refer to
Section 5.4.1 for further information on how to activate additional setpoints.
ñ
NOTE: Choosing an alternate diversion setpoint may be done in either PROGRAM or RUN
mode. If performed in Program mode, the change will not take effect until returning
the unit to Run mode.
1.
ÿû
key to activate Diversion Setpoint Select
2.
Display will show:
STLR SETPOINT SELECT
XXX XXX XXX XXX XXX
3.
The current setpoint will be flashing
Revision 3.0
Section 4
3
