Configuration and Firmware Update
36
NI-3101-SIG Signature Series NetLinx Integrated Controller
7.
From within Studio, select
Tools
>
Firmware Transfers > Send to NetLinx Device
from the Main
menu to open the Send to NetLinx Device dialog (FIG. 27). Verify the target’s System number
matches the value listed within the active System folder in the
OnLine Tree
tab of the Workspace.
The Device number is always 0 for the NI Master
.
8.
Select the NI Master’s Kit file from the
Files
section (FIG. 27).
9.
Enter the
System
number associated with the target Master (
listed
in the OnLine Tree tab of the
Workspace window
) and verify the Device number value.
The Port field is greyed-out.
The Device number is always 0 for the NI Master
.
10.
Click the
Reboot Device
checkbox to reboot the NI unit after the firmware update process is
complete.
11.
Click
Send
to begin the transfer. The file transfer progress is indicated on the bottom right of the
dialog box (FIG. 27).
12.
After the last component fails to install, click
Done.
13.
Click
Reboot
(
from the Tools > Reboot the Master Controller dialog
) and wait for the System
Master to reboot.
The STATUS and OUTPUT LEDs should begin to alternately blink during the
incorporation. Wait until the STATUS LED is the only LED to blink.
FIG. 27
Send to NetLinx Device dialog (showing on-board NI_Master firmware update via IP)
Selected on-board Master firmware file
Description field for selected Kit file
Device and System Number
must match the Device and System values
listed in the Workspace window
Firmware download
status
The Kit file for the NI-2100/3100/3101-SIG/4100 Series of NI Masters begins with
2105_04_NI-X100_Master
.
DO NOT use any Master Kit file other than the one specified, since each Master
Kit file is specifically configured to function on a specific NI unit.
Only upon the initial installation
of a new Kit file to an on-board Master will there
be a error message displayed indicating a failure of the last component to
successfully download. This is part of the NI Master update procedure and requires
that the firmware be reloaded after a reboot of the unit. This consecutive process
installs the final component of the new Kit file.
Содержание FG2105-08
Страница 12: ...Introduction 6 NI 3101 SIG Signature Series NetLinx Integrated Controller...
Страница 46: ...Configuration and Firmware Update 40 NI 3101 SIG Signature Series NetLinx Integrated Controller...
Страница 142: ...NetLinx Security with a Terminal Connection 136 NI 3101 SIG Signature Series NetLinx Integrated Controller...
Страница 175: ...Troubleshooting 169 NI 3101 SIG Signature Series NetLinx Integrated Controller...
