AMX AVB-RX-DGX-SC Fiber-DVI, Инструкция по эксплуатации

Страница: 14 / 79

Overview and Specifications
10 DGX Transmitters & Receivers Instruction Manual
AVB-TX-DGX-HD15-SC Fiber
DGX HD-15 TX Front View
The following components are located on the front of the DGX HD-15 TX (left to right):

Power LED
–
indicates whether or not the module is powered on.

Video and Audio LEDs
–
indicate the presence of video and audio signals through the
module.

EDID LED
–
when the module is in Write-Protect mode, the LED is off (default state); when
the module is in Write-Enable mode, the LED is green. The EDID switch is on the rear.

Video Type LEDs
–
indicate type of signal present: “Y/P
B
/P
R
, RGB” or “RGBHV, RGBS.”

Mode (resolution) button and Auto and Manual LEDs
–
use the Mode button to toggle
between Auto mode (the default mode) and Manual mode to view the difference on the
display when adjusting settings with BoardConfig.

USB mini-B port
–
connect to a control PC and use for overriding the automatic conversion
settings, signal adjustment, firmware upgrades through an Upgrade Tool, live status updates,
and error code reporting.
Important:
If the indicator LEDs do not respond with a normal display as stated in the table below,
check all power connections before contacting technical support (see page 57).
* When a USB cable is connected, the Power LED blinks red while communication is being established with the
PC (see page 67).
** Other than when adjusting settings in BoardConfig, an illuminated Manual LED has no special significance as
the Auto and Manual settings are identical by nature once changes are saved.
FIG. 3 DGX HD-15 TX front view
TX Indicator LEDs
LED Normal Display Indicates
Power* Constant green Power is applied to module (initially red at start up).
Video Constant green A video signal is present through module.
Audio Constant green An audio signal is present through module.
EDID Off EDID is in Write-Protect mode (EDID switch on rear flipped down).
Y/P
B
/P
R
, RGB Constant green A Y/Pb/Pr or RGsB signal is present through module.
RGBHV, RGBS Constant green An RGBHV or RGBS signal is present through module.
Auto
Manual
One is constant green;
the other is off
Module is in Auto mode (default).
Module is in Manual mode** (the mode for adjusting settings when
using BoardConfig).
EDID LED
Power LED
Signal presence LEDs - Video and Audio
Video Type LEDs
USB mini-B port
Mode (resolution) button and LEDs - Auto and Manual