AMX AVB-RX-DGX-SC Fiber-DVI, Инструкция по эксплуатации

Страница: 58 / 79

EDID Programmer
54 DGX Transmitters & Receivers Instruction Manual
To read and save EDID data from the destination:
1.
On the PC, open the EDID Programmer.
2.
Connect a DVI cable to the PC using the PC’s spare monitor port (for cable options for this step, see
“Using Cable Adapters” on page 53).
3. Connect the open end of the DVI video cable to the destination device (typically a monitor) from
which the EDID information needs to be read.
4.
Click the Refresh Display List button to update the Available Displays drop down list.
5.
From the Available Displays drop down list, select the destination device from which you need to
read the EDID.
6. Click the Read button to read the EDID information. The results display in the read-only area.
7.
Click the Save button (select location, enter file name, and click Save).
Leave the EDID Programmer open for the instructions on writing the EDID to the TX on the next
page.
8. Disconnect the DVI cable from the PC and from the destination device.
Available Displays drop down list – select device
Close – shuts down application; will not prompt to save
Open – an EDID file
Save – an EDID file to edit or to write to input on module
Refresh Display List – updates list after additional devices attached
Convert to Digital / Convert to Analog – converts displayed EDID data
Query AMX Device – acquires XNNet ID address of device
EDID Information – data (read-only) from file or display device
EDID Type – indicates analog or digital (read-only)
Read – reads EDID from selected destination device
Write – writes EDID to input on module
Communication menu – use to select PC serial port or change baud rate
Status – shows application status (read-only)
Target Device – select Accessory Module