AMX AVB-RX-DGX-SC Fiber-DVI, Инструкция по эксплуатации

Страница: 38 / 79

Installation and Setup
34 DGX Transmitters & Receivers Instruction Manual
To wire the RS-232 port on the RX for data transfer:
1.
Wire the RS-232 connector according to the pinout directly above the connector (FIG. 25).
RX – Applying Power
Caution:
If you are providing the power supply, use a UL (or equivalent) listed power supply.
To avoid damage to the module, the electrical ratings must not exceed those indicated in the
“Specifications” table on page 18.
To apply power to the RX:
1.
Plug the cord from the desktop power supply (provided) into the power jack on rear of the RX.
2.
Plug the desktop power supply into an AC external power source.
The Power LED on the front of the RX initially turns red and after a moment it turns a constant
green, indicating a ready state.
Some of the additional LEDs will also turn a turn a constant green; for LED states on initial power
up, see the table below.
Note:
On power up, the blower will toggle to a high (full on) state briefly until the CPU takes
over, at which time the blower will go to its normal operational state.
DGX HD-15 RX and DGX DVI RX – Indicator LEDs at Initial Power Up
* If the output cable is disconnected from the RX or if no EDID can be found on the destination device, the
Bypass LED will be constant green and the Auto LED will blink. This indicates that the RX has switched to the
Bypass Scaling option and is waiting for EDID information. As soon as a valid EDID is found, the RX will revert to
the Auto Scaling option.
For information on restoring the RX default settings on power up, see page 71.
FIG. 25 Wire RX for RS-232 data transfer
RX LED Normal State Indicates
Power Constant red
Constant green
Initial application of power (red for a brief time only).
Power is in an operational state.
Video Constant green A video signal is present through the RX.
Audio Constant green An audio signal is present through the RX.
Scaling – Bypass
– Auto
– Manual
Off
Constant green*
Off
At initial power up, the RX defaults to the Auto Scaling
option.*
Press Scaling button to turn on the Bypass option or Manual
option.
RS-232 pinout