AMX AVB-RX-DGX-SC Fiber-DVI, Инструкция по эксплуатации

Страница: 44 / 79

Scaling Options
40 DGX Transmitters & Receivers Instruction Manual
Before starting the Scaler Override procedure (applies to either DGX RX):
 
Connect the DGX RX to a PC using a USB (mini-B) cable (FG10-5965 provided).
A virtual COM port must be established; see page 67.
  On the PC, install the Scaler Override utility from www.amx.com .
(A) To set an EDID for the RX from the detected device:
Note:
If the Manual option is not selected in Step 1, the RX automatically goes to the Manual option
when the utility is opened or when either the Apply or the Save button in the utility is selected. (If the
Save button is selected, the Manual option persists when power is cycled on the RX.) The Manual option
remains selected until the Scaling button on the RX is pressed to activate another option.
1.
Press the Scaling button on the RX once or twice (depends on the current selection) until the Manual
LED illuminates green.
2. Open the Scaler Override utility (it automatically queries the destination device for EDID information).
The EDID Status section indicates that the EDID information has been found for the detected device or
that a list of standard resolutions is available).
3. Under Aspect Ratio, click either Maintain Aspect Ratio or Stretch to Fit (for descriptions of both, see
page 44).
4.
Under Resolution Source, click EDID.
5.
Under EDID from Detected Device, select desired resolution from the Available Display Modes list.
6. Click Apply to transmit the selected information to the RX. This action is temporary (and you can still
cycle through the Scaling options on the RX); settings are not stored on the RX until Step 8; otherwise,
the settings last only until power is cycled. The display re-syncs with the module.
7. Verify that the display is satisfactory before proceeding.
8. Click Save* to store the currently displayed settings (if the setting have been changed since clicking
Apply, the newest settings will be saved) on the RX and persist them in memory. (The RX will power up
in the Manual option.)
* If you click Close instead of Save immediately after applying settings, the utility asks if you want to save
prior to exiting. Selecting Yes applies the settings, persists them on the RX, persists the Manual mode on the
RX over power cycles, and closes the utility. Selecting No closes the utility; the applied settings are still in
effect and can be accessed under the Manual option. However, they are not stored on the RX and on power
cycle, the RX will revert to its previously stored settings.
FIG. 30
Scaler Override utility with EDID selected
Select EDID
Option A